How to measure Base Size?
In order to make the most fitting hair system for you, it’s important to know the right measures of your base size. You can either send us your template or measure it on your own by following the instructions laid below-
Measure a full cap:
1. The Circumference of the Head
In order to measure the circumference of your head position the tape to the edges of your head. Following the hairline and nape of your neck rap it all around the head.
2. From Forehead to Nape of Neck
Position the measuring tape to the hairline of your head and take it straight back over the crown towards the nape of neck.
3. Ear to Ear across Front Hairline:
Measure along the forehead, across the hairline from the base of one sideburn to the other.
4. From Ear to Ear Over Top of Head
Measure directly above the ear from hairline across the crown of the head towards the side of the hairline lying directly above the other ear.
5. Point to Point
To know about point to point base size, position the measuring tape across the back head region, from temple to temple.
6. Nape of Neck
Just measure the width of hairline, by measuring across the nape of the neck.
Helpful hints for taking good measurements:
Use a cloth measuring tape to know about the exact size figure
Don’t hold the measuring tape too tight when measure the size
Keep the tape flat and make sure the tape isn’t kinked or twisted when measuring
In order to get ensured perfect measurement, it’s wise to take the measurements minimum 3 times using the same tape. This will ensure you that you are taking the measurements correctly
How to make a template